Aritech ATS4000 Manuel de service télécharger pdf (Page 60)

60 ATS Designers Guide

Table 4-4 Available DGP modules and their expansions.

Zones Outputs Remarks Expansion

MBC ATS1202 ATS1810 ATS1811 ATS1820

ATS1201 8 3x8 2x4 2x8 1x16 Max outputs 16

ATS1203 8 3x8 2x4 4x8 2x16 Max outputs 32

ATS1210/11 8 2x4 2x8 1x16

ATS1220 4

ATS1290 32

ATS1230 32

The housing does not

allow installation of

additional expansions ,

device without a power

supply.

Planning for maximum DGP expansion the maximum system capacity – 256 zones- can

be achieved using 7 DGP modules. In an opposite case – using the mentioned 4 zone

DGP – after installing all possible DGP modules – 15 – all the expansions would make

total of 60 alarm zones.

4.2.1.2 Outputs

A similar rule is valid for the division of the system output address space. The output

addresses for a given DGP are defined by it’s address – number – in the system. DGP

can support a maximum of 16 outputs, which is the same as it’s assigned zone address

space. The control panel can support all the outputs, but due to power supply limits the

number is capped at 150. A higher number of outputs can be made available by installing

an additional power source.

Each system output is limited by a timezone. The system supports 16 areas, and for each

one a separate external and internal siren. The ATS1201 DGP is equipped with

dedicated, monitored siren output, addressed like the rest of the system outputs.

Table 4-5 Alarm zone and output addressing in the ATS system.

Input Range Output Range DGP Address Remarks

1-16 1-16 16 (CP) Control panel alarm zones

17-32 17-32 1

33-48 33-48 2

49-64 49-64 3

65-80 65-80 4

81-96 81-96 5

97-112 97-112 6

113-128 113-128 7

129-144 129-144 8

145-160 145-160 9

161-176 161-176 10

177-192 177-192 11

193-208 193-208 12

209-224 209-224 13

225-240 225-240 14

241-256 241-255 15 Output 256 is not available

4.2.1.3 Sirens

Each of the 16 areas can have two signallers defined: internal and external. Configuring

the sirens in the system is the same as configuring the outputs: the event flag is assigned

to an output. Apart from the control panel, the siren outputs are available in the ATS1201,

ATS1203 and ATS1250/60 DGP. The signaller outputs are protected by fuses and

monitored. By default the system is programmed to activate all external sirens in case of

an alarm in any area.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 82 83

Commentaires sur ces manuels

Pas de commentaire

Aritech ATS4000 Manuel de service Page 60

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Aritech ATS4000