Aritech ADVISOR CD 7203 Manuel d'utilisateur télécharger pdf (Page 50)

Page 50 Manager Manual for CD72/95/15003

DISARMING A SPLIT SYSTEM AS A BASIC OR STANDARD USER

If you enter the premises when the system is armed, the beeper will begin to beep with an intermittent tone to

indicate that the entry period has begun. During the beeping, you must not enter other areas of the system. If

you do, an alarm will be triggered. During this entry period you can disarm the system with your code. This

entry period has been programmed by the installer.

Because the system is split, you can select one or more areas from the available security areas.

1. The current status of the areas is shown in the display. Both

areas a fully armed.

[1] [2]

The entry period starts as soon as you open the entrance

door, or when you enter the entry zone. You can switch off

the system without activating the alarm as long as the

beeping continues. As soon as the beeping starts, the

display is illuminated.

Beep

2. Press the 0 key and then enter your code. A ‘*’ appears in

the display for every key you press. Use the 0 key to cancel

an incorrect entry.

Enter Code

0 + code

Enter Code ****

An underscore appears alternately under ‘1’ and ‘2’. Enter

the number of the area required.

[1] [2]

3. To disarm area 1, therefore, enter ‘1’.

1 2 3

4 5 7

7 8 9

Area 1 is automatically disarmed.

Disarm?

4. An underscore appears again alternating under ‘1’ and ‘2’ to

indicate that you can use an area. If you also want to disarm

area 2, enter ‘2’.

If there have been alarms or faults since the system was armed,

‘In Operator Log’ will appear instead of ‘1 [[2]]’. See also

‘Disarming after an alarm as a basic or standard user’ on 52.

1 [2]

Area 1 is disarmed and area 2 is still fully armed.

1 [2]

Technical Manuals Online! - http://www.tech-man.com

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 107 108

Pas de commentaire

Aritech ADVISOR CD 7203 Manuel d'utilisateur Page 50